Monday, May 9, 2011

Home » » » Delayed Turn-On Relay Circuit Using NOR Gate 4001

Delayed Turn-On Relay Circuit Using NOR Gate 4001

This is a delayed turn-on relay driver and can produce time delays for up to several minutes with reasonable accuracy. The 4001 CMOS gate here is configured as a simple digital inverter. Its output is fed to the base of a regular 2N3906 transistor, Q1, at the junction of resistor R5 and capacitor C2. The input to IC1 is taken from the junction of the time-controlled potential divider formed by R2 and C1. Before power is applied to the circuit, C1 is fully discharged. Therefore, the inverter input is grounded, and its output equals the positive supply rail; Q1 and RY1 are both off under this circuit condition. When power is applied to the circuit, C1 charges through R2, and the exponentially rising voltage is applied to the input of the CMOS inverter gate.

After a time delay determined by the RC time constant values of C1 and R2, this voltage rises to the threshold value of the CMOS inverter gate. The gate's output then falls toward zero volts and drives Q1 and relay RY1 'ON'. The relay then remains automatic turn-off relay driveron until power is removed from the circuit. When that occurs, capacitor C1 discharges rapidly through diode D1 and R1, completing the sequence. The time delay can be controlled by different values for C1 and R2. The delay is approximately 0.5 seconds for every µF as value for C1. The delay can further be made variable by replacing R2 with a fixed and a variable resistor equal to that of the value of R2. Taken the value for R2 of 680K, it would be a combination of 180K for the fixed resistor in series with a 500K variable trim pot. The fixed resistor is necessary.

No comments:

Post a Comment

Note: Only a member of this blog may post a comment.